Pressure relief sensor - r r

Operation 1060G16 · Pressure pump electric control

1.9 JTD 8V

Removing

Disconnect the battery negative (-) terminal.

- 1016A10 sound-proofing cover - r + r

1. Disconnect the electrical connection from the excess pressure sensor.

2. Withdraw the retaining bolt.

3. Remove the excess pressure sensor

Refitting

Position the excess pressure sensor.

Tighten the bolt.

Connect the electrical connection

- 1016A10 sound-proofing cover - r + r

Connect the battery terminal (-).

1.9 JTD 16V

Removing

Proceed with removal - 7025A12 Engine front sound insulation COVER - R.R..

Proceed with removal - 7025A14 Bonnet LID - R.R..

Proceed with removal - 1016A10 sound-proofing cover - r + r.

Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

1. Disconnect the electrical connection from the excess pressure sensor.

2. Undo the bolt (2a), remove the excess pressure sensor (2b).

Refitting

Replace the excess pressure sensor in its housing and fix it using the bolt.

Connect the electrical connection to the excess pressure sensor.

Connect the negative (-) battery terminal.

Proceed with refitting - 1016A10 sound-proofing cover - r + r.

Proceed with refitting - 7025A14 Bonnet LID - R.R..

Proceed with refitting - 7025A12 Engine front sound insulation COVER - R.R..