Cam angle sensor - r r

Operation 1060G22 · Pressure pump electric control

1.9 JTD 8V

Removing

- 1016A10 sound-proofing cover - r + r

- 1008C10 power unit upper reaction link r r

- 1008C14 engine link bracket - r r

- 1060G80 ds electric injection control unit - r r

- 4450B04 right front wheel r r

- 7055B54 under-engine guard - r r

- 7055B64 Engine compartment DUST shield in front wheel arch (one), left or right - R.R.

- 1092G10 single engine belt r r

- 1092A10 Crankshaft services PULLEY - R.R.

- 1032B10 toothed timing belt - r + r for timing adjustment or replacement

- 1032B40 toothed-driven pulley (one) - r + r with timing belt removed

1. Undo the bolts (1a) and remove the side timing belt protection (1b).

2. Disconnect the electrical connection for the cam angle sensor located near the engine oil dipstick tube.

3. Undo the bolts (3a) and remove the cam angle sensor (3b).

Refitting

Fit the sensor and tighten the retaining bolt.

Tighten the sensor bolts to torque.

Connect the electrical connection

Position the timing belt side shield and tighten the fixing bolts.

- 1032B40 toothed-driven pulley (one) - r + r with timing belt removed

- 1032B10 toothed timing belt - r + r for timing adjustment or replacement

- 1092A10 Crankshaft services PULLEY - R.R.

- 1092G10 single engine belt r r

- 7055B64 Engine compartment DUST shield in front wheel arch (one), left or right - R.R.

- 7055B54 under-engine guard - r r

- 4450B04 right front wheel r r

- 1060G80 ds electric injection control unit - r r

- 1008C14 engine link bracket - r r

- 1008C10 power unit upper reaction link r r

- 1016A10 sound-proofing cover - r + r

1.9 JTD 16V

Removing

Proceed with removal - 1016A10 sound-proofing cover - r + r.

Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

1. Disconnect the electrical connection from the cam angle sensor.

2. Undo the bolt (2a) and remove the cam angle sensor (2b).

Refitting

1. Plact the cam angle sensor (1a) back in its housing and secure it tightening the bolt (1b) to the recommended torque.

2. Connect the electrical connection to the cam angle sensor.

Connect the negative (-) battery terminal

Proceed with refitting - 1016A10 sound-proofing cover - r + r.