Ds electric injection control unit - r r

Operation 1060G80 · Pressure pump electric control

1.9 JTD 8V

Removing

Disconnect the battery negative terminal.

1. Disconnect the electrical connection from the injection electronic control unit.

2. Undo the retaining nuts.

3. Remove the engine control unit from its seat on the strut.

Refitting

Fit the control unit in its seat.

Tighten the bolts retaining the support bracket to the bodyshell.

Connect the electrical connections to the control unit.

Connect the battery negative terminal.

1.9 JTD 16V

Removing

Proceed with removal - 7025A12 Engine front sound insulation COVER - R.R..

Proceed with removal - 7025A14 Bonnet LID - R.R..

Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

1. Remove the engine oil filler cap.

2. Undo the fixing bolts (2a) and remove soundproofing cover (2b).

Tighten the engine oil filler cap.

1. Disconnect the electrical connections (1a) and (1b) from the diesel electronic injection system control unit.

1. Undo the nuts (1a) and remove the diesel electronic injection system control unit (1b) complete with slides (1c).

Refitting

Place the diesel electronic injection control unit complete with slides back in its housing with its bracket and secure it using the nuts.

Connect the electrical connections to the diesel electronic injection control unit.

Remove the engine oil filler cap.

Place the soundproof cover back in its housing and secure using the relevant bolts.

Tighten the engine oil filler cap.

Connect the negative (-) battery terminal.

Proceed with refitting - 7025A14 Bonnet LID - R.R..

Proceed with refitting - 7025A12 Engine front sound insulation COVER - R.R..