Brake pedal switch - r r

Operation 1060G38 · Pressure pump electric control

1.9 JTD 8V

Refer to op. 5550D10 brake light switch - r+r

1.9 JTD 16V

Removing

Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

1. Turn the switch on the brake pedal clockwise through 90 degrees and remove it.

2. Disconnect the electrical connection from the switch on the brake pedal.

3. Remove the brake pedal switch.

Refitting

1. Press the brake pedal, then refit the brake pedal switch and turn through 90 degrees anticlockwise until it clicks home.

Release the brake pedal.

Connect the electrical connection to the switch on the brake pedal.

Connect the negative (-) battery terminal.

Check the operation of the brake lights.