Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat 500 Factory Service Manual (2007-2024)06 · Maintenance
06 · Maintenance

150,000km service

Make
Fiat
Model
500 Factory Service Manual
Year
2007–2024
Section
New vehicles and maintenance › 150,000km service
Maintenance150,000km service

150,000KM SERVICE

Operation 0010M50 · SERVICE COUPONS FROM 100,000 UP TO 190,000KM - EMISSION CONTROL VERSIONS

1.2 8v, 1.3 Multijet, 1.4 16v

- Check the tyre tread is not worn.

Some types of tyre are fitted with wear gauges; they should be replaced as soon as these gauges are visible on the tread.

Do not swap tyres across.

- Check the tyre inflation pressure is correct. Also check the spare wheel.

The tyre pressures must be checked when they are cold.

- Check that the lighting system is operating correctly: headlamps, direction indicators, hazard lights, luggage compartment lights, passenger compartment light and instrument panel warning lights.

- Check the windscreen wash/wipe system is operating correctly and adjust the jets if necessary.

- Check the front and rear wiper blades are correctly positioned and not worn.

- Check the condition and wear of front disc brake pads and operation of pad wear indicator

- Carry out a visual check of: exterior bodywork, underbody protection, rigid and flexible pipes (exhaust - fuel system - braking system), rubber elements (gaiters - hoses - bushes - etc.)

- Check cleanliness of locks, bonnet and boot lids, cleanliness and lubrication of linkage

- Check and if necessary adjust the handbrake lever travel; refer to

Op. 3380A04 HANDBRAKE - ADJUST TRAVEL

- Replace air filter cartridge (only for 1.3 Multijet versions); refer to

Op. 1048A14 AIR CLEANER FILTER ELEMENT - REPLACE.

- Restore the brake-clutch fluid level; refer to

Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY

- Restore the engine coolant level; refer to

Op. 0010T21 ENGINE COOLANT - CHECK DENSITY AND TOP UP, IF NECESSARY

- Restore the battery fluid, windscreen washer fluid level, etc.

- Replace the spark plugs (only in petrol versions); refer to

Op. 5510D10 SPARK PLUGS - R+R

- Check the operation of the engine control systems (using the diagnostic socket).

- Change engine oil and oil filter (or every 12 months); refer to

If the vehicle is used mainly around town or does less than 10,000 km per year, the engine oil and engine oil filter must be changed every 12 months

Op. 0010T12 ENGINE OIL AND FILTER - REPLACE

- Replace the pollen filter (or every 12 months); refer to:

Op. 5010B08 CLIMATE CONTROL OUTSIDE AIR PURIFYING (POLLEN) FILTER - R.R.

- Check exhaust emissions (only in petrol versions); refer to

Op. 1080A10 IDLING C.O. LEVEL - CHECK WITH SPECIAL EQUIPMENT

- Check exhaust/smoke emissions (only in petrol versions); refer to

Op. 1080A20 EXHAUST FUMES - CHECK WITH OPACIMETER

- At the end of the service, connect the Examiner diagnostic equipment to the on board diagnostic socket to zero the mileage counter for the days to the starting value and write the details of the service that has been carried out (date, service number, total mileage) in the Trip Computer memory which can only be read using the diagnostic equipment.

Check that the figure has been set in the instrument panel in km or miles depending on the unit of measurement in that country.

Parts & tools for this job For 2007 Fiat 500

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.