60,000KM SERVICE

Operation 0010K60 · PROGRAMMED MAINTENANCE, EMISSION CONTROL VERSIONS UP TO 90,000KM

1.2 8v, 1.3 Multijet, 1.4 16v

- Check the tyre tread is not worn.

Some types of tyre are fitted with wear gauges; they should be replaced as soon as these gauges are visible on the tread.

Do not swap tyres across.

- Check the tyre inflation pressure is correct. Also check the spare wheel.

The tyre pressures must be checked when they are cold.

- Check that the lighting system is operating correctly: headlamps, direction indicators, hazard lights, luggage compartment lights, passenger compartment light and instrument panel warnings lights.

- Check the windscreen wash/wipe system is operating correctly and adjust the jets if necessary.

- Check the front and rear wiper blades are correctly positioned and not worn.

- Check the condition and wear of the front disc brake pads and the operation of the pad wear indicator

- Check the condition and wear of the rear drum brake seals (where present).

- Carry out a visual check of: exterior bodywork, underbody protection, rigid and flexible pipes (exhaust - fuel system - braking system), rubber elements (gaiters - hoses - bushes - etc.).

- Check cleanliness of locks, bonnet and boot lids, cleanliness and lubrication of linkage

- Carry out a visual check on the auxiliary drivebelt.

- Check and, if necessary, adjust the tappet clearance (only for 1.2 8v engines); refer to

Op. 1036H14 VALVE TAPPETS - CHECK CLEARANCE

- Check and if necessary adjust the handbrake lever travel; refer to

Op. 3380A04 HANDBRAKE - ADJUST TRAVEL

- Check the condition and wear of the rear disc brake pads (where present).

- Replace the air cartridge filter; refer to

Op. 1048A14 AIR CLEANER FILTER ELEMENT - REPLACE.

- Restore the brake-clutch fluid level; refer to

Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY

- Restore the engine coolant level; refer to

Op. 0010T21 ENGINE COOLANT - CHECK DENSITY AND TOP UP, IF NECESSARY

- Restore the battery fluid, windscreen washer fluid level, etc.

- Carry out a visual check of the timing belt (only for petrol versions).

Or every 4 years for heavy usage (cold climates, town driving with long idling stops, dusty areas).

- Replace the spark plugs (only for petrol versions); refer to

Op. 5510D10 SPARK PLUGS - R+R

- Check the operation of the engine control systems (using the diagnostic socket).

- Change engine oil and oil filter (or every 12 months); refer to

If the vehicle is used mainly around town or does less than 10,000 km annually, the engine oil and engine oil filter must be changed every 12 months

For 1.3 Multijet engines with DPF system, the engine oil and filter should be replaced when the warning light in the instrument panel comes on or every 24 months.

Op. 0010T12 ENGINE OIL AND FILTER - REPLACE

- Replace the brake/clutch fluid (or every 24 months); refer to:

Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY

Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR

- Replace the pollen filter (or every 12 months); refer to:

Op. 5010B08 CLIMATE CONTROL OUTSIDE AIR PURIFYING (POLLEN) FILTER - R.R.

- Check the exhaust emissions (only for petrol versions); refer to

Op. 1080A10 IDLING C.O. LEVEL - CHECK WITH SPECIAL EQUIPMENT

- Check the exhaust emissions/fumes (only for 1.3 Multijet); refer to

Op. 1080A20 EXHAUST FUMES - CHECK WITH OPACIMETER

- Replace the fuel filter (only for 1.3. Multijet); refer to

Op. 1044B10 FUEL FILTER ASSEMBLY - R + R OR REPLACE

At the end of the service, connect the Examiner diagnostic equipment to the on board diagnostic socket to zero the mileage counter for the days to the starting value and write the details of the service that has been carried out (date, service no., total mileage) in the Trip Computer memory which can only be read using the diagnostic equipment.

Check that the figure has been set in the instrument panel in km or miles depending on the unit of measurement in that country.