Water pump - r + r with timing belt(s) removed
- Make
- Fiat
- Model
- Grande Punto Factory Service Manual
- Year
- 2005–2012
- Section
- Engine cooling › Water pump - r + r with timing belt(s) removed
WATER PUMP - R + R WITH TIMING BELT(S) REMOVED
Removing
1. Undo the bolts (1a) and remove the coolant pump (1b) complete with gasket.
Refitting
- Refit the water pump, complete with gasket, in its housing and secure it tightening the bolts to the recommended torque.
| Component | Fastening | dia | Value (daNm) | Validity |
|---|---|---|---|---|
| Water pump | Bolt | M8 | 2.2 ÷ 2.7 | 1.9 Multijet |
Removing
Op. 0010T20 ENGINE COOLANT - CHANGE
1. Undo the bolts fixing the water pump to the crankcase.
2. Remove the water pump from the crankcase.
Refitting
- Clean the residues of sealant from the mating surfaces between the engine block and the water pump.
- Apply a strip of silicone sealant to the contact surfaces between the water pump and the engine block.
- Position the water pump in its housing and secure it tightening the bolts to the recommended torque.
| Component | Fastening | dia | Value (daNm) | Validity |
|---|---|---|---|---|
| Water pump | Bolt | M8 | 0.8 ÷ 1.0 | 1.2 8v 1.4 8v |
Parts & tools for this job For 2005 Fiat Grande Punto
- PARTTiming belt kitSearch: Fiat Grande Punto 2005 timing belt kit
- TOOLEngine timing tool setSearch: Fiat engine timing tool set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.