Discovery II
AUTOMATIC GEARBOX - ZF4HP22 - 24
REPAIRS
44-39
12. Check that the axial end-float is between 0.2 to
0.4 mm. If end-float is not within limits, replace
existing thrust washer, positioned at rear of
intermediate plate, with a suitable thickness
thrust washer to give the required end-float.
13. Remove DTI gauge and base plate.
14. Fit torque converter oil seal.
- 24, REPAIRS, Torque converter and oil
seal.
Gasket - intermediate plate
$% 44.20.11
Remove
1. Remove torque converter oil seal.
- 24, REPAIRS, Torque converter and oil
seal.
2. Remove 12 bolts and plain washers securing
converter housing and intermediate plate to
gearbox casing. Note the position of the 4 bolts
that have sealant applied to the bolt threads.
3. Hold input shaft in position and carefully lift off
converter housing and intermediate plate as an
assembly. Note the position of the Torrington
race on the forward clutch hub, and the thrust
washer which will stay attached to the
intermediate plate by fluid adhesion.
4. Remove and discard intermediate plate gasket.
5. Remove thrust washer from intermediate plate.
M44 1344
M44 1345