Discovery II
AUTOMATIC GEARBOX - ZF4HP22 - 24
REPAIRS
44-25
Switch - starter inhibitor
$% 44.15.19
Remove
1. Diesel models: Remove exhaust front pipe.
SYSTEMS - Td5, REPAIRS, Pipe - front.
2. Move the selector lever to position 'P'.
3. Remove nut securing selector lever to gearbox
selector shaft and release lever.
4. Remove 2 bolts securing inhibitor switch to
gearbox.
5. Release multiplug from gearbox bracket.
6. Release inhibitor switch from selector shaft.
7. Disconnect switch multiplug and remove
switch.
Refit
1. Ensure 'P' is selected by rotating selector shaft
fully clockwise.
2. Engage 'N' by rotating selector shaft 2 detents
anti-clockwise.
3. Position inhibitor switch to selector shaft,
connect multiplug and secure multiplug to
gearbox bracket.
4. Engage switch to selector shaft, and fit but do
not tighten retaining bolts.
5. Fit tool LRT-44-011 to selector shaft.
6. Insert setting pin into tool. Rotate switch until
setting pin engages with hole in switch as
shown and tighten bolts to 10 Nm (7 lbf.ft).
7. Remove setting tool LRT-44-011.
8. Position selector lever to selector shaft and
tighten nut to 26 Nm (19 lbf.ft).
9. Diesel models: Fit exhaust front pipe.