L322 Range Rover Service Procedures
STEERING
REPAIRS
57-29
4. Position PAS pump to mounting, fit Allen bolts
and securing nut. Tighten Allen bolts to 10 Nm
(7 lbf.ft) and securing nut to 25 Nm (18 lbf.ft).
5. Remove plug connections, connect PAS feed
hose to PAS pump and secure with clip.
6. Clean PAS pump and pipe union.
7. Fit new 'O' ring to high pressure pipe union,
align to PAS pump and tighten PAS pump high
pressure pipe union to 25 Nm (18 lbf.ft).
8. Fit ancillary drive belt to all pulleys except
tensioner pulley.
9. Fit ancillary drive belt to tensioner pulley.
Ensure ancillary drive belt is aligned to all
pulleys.
10. Tension ancillary drive belt.
11. Tighten tensioner clamp bolts to 30 Nm (22
lbf.ft).
12. Fit undertray.
13. Connect battery earth lead.
14. Fill and bleed PAS system.
assisted steering (PAS) system - bleed.
Column assembly - inner & outer
$% 57.40.01
Before disconnecting the battery, ensure all text and
cautions in the battery disconnection section are
observed.
GENERAL INFORMATION, Electrical
Remove
1. Move drivers seat fully rearwards for access.
2. Remove drivers side footwell closing panel.
Closing panel - driver's side.
3. Secure bonnet in upright position using service
clips.
4. If steering wheel is not locked, turn wheel to
obtain better access to steering column shaft
upper Torx clamp bolt.
5. Disconnect battery earth lead.
6. Working from under bonnet, remove and
discard upper Torx bolt from steering coupling.
7. Remove rotary coupler assembly.