L322 Range Rover Service Procedures
STEERING
57-32
REPAIRS
Sensor- steering angle/column
$% 57.40.02
Remove
1. Remove steering column assembly.
2. Release steering angle sensor from retaining
clip and remove from shaft.
Refit
1. Position steering angle sensor to shaft and
secure to retaining clip.
NOTE: Make sure the steering angle sensor is
correctly aligned to the steering shaft.
2. Fit steering column assembly.
3. Testbook/T4 must be used to initiate a new
steering angle sensor. The initiation procedure
can be found in Testbook/T4 by selecting the
following icons.
l
System diagnosis
l
ABS
l
Vehicle maintenance
Nacelle - column - complete
$% 57.40.29
Remove
1. Fully extend the steering column for access.
2. Remove 3 Torx screws securing steering
column nacelle.
Steering wheel removed from graphic for
illustration purposes only.
3. Release nacelle from clips securing assembly
to column extension gaiter
4. Remove steering column nacelle.
Refit
1. Push steering column extension gaiter fully
forwards and fit lower half of nacelle.
2. Fit and tighten the 2 T25 Torx screws.
Ensure the lower half of nacelle does not
foul the steering wheel.
3. Fit upper half of nacelle and ensure that clips
engage with lower half.
4. Secure upper half of nacelle with T20 Torx
screw.
5. Fit and secure steering column extension gaiter
to nacelle.
Ensure the nacelle does not foul the
steering wheel.