L322 Range Rover Service Procedures
STEERING
57-10
REPAIRS
9. Ensure pinion timing marks are aligned and
connect column to PAS rack. Fit and tighten
clamp screw to 24 Nm (18 lbf.ft).
10. Position height sensor assembly to sub-frame,
fit and tighten bolts to 2.5 Nm (1.8 lbf.ft).
CAUTION: Ensure height sensor arm is
pointing outwards.
11. Connect height sensor multiplug.
12. Correctly position height sensor harness and
secure with cable ties. Ensure the harness is
not under tension.
13. Connect anti-roll bar links, fit nuts and tighten to
100 Nm (74 lbf.ft).
14. Clean track rod end tapers and taper seats.
15. Connect track rod ends to steering arms, fit new
nuts and tighten to 80 Nm (59 lbf.ft).
16. Fit LH drive shaft.
17. Fit air flow panel and tighten bolts to 45 Nm (33
lbf.ft).
18. Fit undertray.
19. Lower the lift.
20. Fit road wheel(s) and tighten nuts to 140 Nm
(103 lbf.ft).
21. Remove stands and lower the vehicle.
22. Connect battery earth lead.
23. Bleed PAS system.
assisted steering (PAS) system - bleed.
24. Check and adjust front wheel alignment.
wheel alignment - check & adjust.
Power steering rack - left hand drive - V8
$% 57.10.01
Before disconnecting the battery, ensure all text and
cautions in the battery disconnection section are
observed.
GENERAL INFORMATION, Electrical
Remove
1. Disconnect battery earth lead.
2. Raise front of vehicle and support on stands.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
3. Remove front road wheels.
4. Remove undertray.
5. Remove 4 bolts securing the air flow panel and
remove panel.
6. Remove LH front height sensor.
7. Remove LH front drive shaft.
8. Remove and discard nut securing RH track rod
end ball joint to steering arm.