LR3/Disco 3
25 .
CAUTION: During timing chain tensioner compression, do not release the ratchet stem until
the timing chain tensioner piston is fully bottomed in its bore or damage to the ratchet stem will
result.
Install the RH primary chain tensioner.
Using 3 mm diameter metal rod, retain the chain tensioner piston.
Tighten the bolts to 12 Nm (9 lb.ft).
Remove the retaining rod.
26 .
CAUTION: Using the special tool apply force to the tool in an anti-clockwise direction to
tension the primary timing chain on its drive side.
CAUTION: The intake camshaft sprocket retaining bolt MUST be tightened before the exhaust
camshaft sprocket retaining bolt. Engine damage will occur if this procedure is not followed.
Install the special tool to the exhaust camshaft sprocket.
Tighten the intake camshaft sprocket retaining bolt to 120 Nm (88 lb.ft).
Tighten the exhaust camshaft retaining bolt to 120 Nm (88 lb.ft).
27 .
Install the RH VCT control unit.
Install the new O-ring seals.
Tighten the new bolts to 22 Nm (16 lb.ft).
28 .
Remove the special tool from the LH cylinder head.
29 .
Remove the special tool from the RH cylinder head.
30 .
Remove the crankshaft locking tool.
Remove the screw.
31 .
Install the CKP sensor. For additional information, refer to
Crankshaft Position (CKP) Sensor
(18.30.12)
(Section 303-14)
32 .
NOTE :
