Range Rover P38
BMW DIESEL
21
REPAIR
CAMSHAFT
Service repair no - 12.13.02
Remove
1. Remove camshaft cover.
See this section.
Vehicles with EGR: Remove EGR vacuum
pump.
See EMISSION CONTROL, Repair.
2. Remove bolt securing harness trunking, recover
nut plate.
3.
Vehicles without EGR: Remove 2 bolts securing
camshaft front cover plate, remove cover plate;
remove and discard ’O’ ring. Lay harness
trunking aside.
4. Remove plastic plug from flywheel/drive plate
timing pin access hole.
5. Rotate crankshaft clockwise until No.1 piston is
at top dead centre (TDC) on its compression
stroke. Insert timing pin LRT-12-108 into hole in
flywheel/drive plate.
NOTE: TDC No. 1 is indicated when
camshaft lobes of No. 1 cylinder are
positioned as shown.