Range Rover P38
BMW DIESEL
45
REPAIR
Refit
10. Ensure mating faces are clean.
11. Clean sump.
12. Fit gasket to sump. Fill front and rear openings in
gasket with STC 3373 sealant.
13. Position sump to cylinder block.
14. Secure sump with bolts.
M6 -
10 Nm (7 lbf.ft)
M6 -
12 Nm (9 lbf.ft)
M8 -
20 Nm (15 lbf.ft)
15. Tighten sump plug to:-
M12 -
25 Nm (18 lbf.ft)
M22 -
60 Nm (44 lbf.ft)
16. Position power steering pump bracket on sump.
Secure with bolt.
17. Raise lift. Remove chassis support.
18. Lower lift.
19. Lubricate new dipstick tube ’O’ ring with clean
engine oil.
20. Fit ’O’ ring to dipstick tube. Fit tube. Secure with
nut and bolt.
21. Refill engine oil.
See LUBRICANTS, FLUIDS
AND CAPACITIES, Information.
22. Reconnect battery negative lead.
BIG-END BEARINGS
Service repair no - 12.17.16
Remove
1. Remove sump.
See this section.
2. Remove 3 bolts securing oil pick-up pipe.
3. Remove oil pick-up pipe, remove and discard
seal.