Range Rover P38
BMW DIESEL
35
REPAIR
42. Fit protection sleeve LRT-12-104 on valve stem.
43. Fit new valve stem oil seal.
NOTE: Inlet valve stem oil seals are
coloured RED whilst exhaust valve stem
oil seals are coloured GREEN.
44. Press valve stem oil seal into position using tool
LRT-12-071, remove protection sleeve
LRT-12-104.
45. Fit valve spring seat, new valve spring and
spring cup.
46. Compress valve spring using tool LRT-12-034, fit
2 collets.
47. Remove protection sleeve LRT-12-101.
48. Repeat procedures for remaining valves.
49. Lubricate tappet bores and tappets with engine
oil, fit tappets to their original locations.
50. Fit cylinder head.
See this section.
51. Fit exhaust manifolds.
See MANIFOLD AND
EXHAUST SYSTEM, Repair.
52. Fit glow plugs.
See FUEL SYSTEM, Repair.
53. Fit injectors.
See FUEL SYSTEM, Repair.
54. Fit inlet manifolds.
See MANIFOLD AND
EXHAUST SYSTEM, Repair.
55. Fit camshaft.
See this section.
OIL COOLER
Service repair no - 12.60.68
Remove
1. Remove intercooler.
See FUEL SYSTEM,
Repair.
2. Remove 2 trim fixing studs securing LH deflector
panel. Remove panel.
3. Position container to catch oil spillage.
4. Disconnect oil cooler upper hose. Remove ’O’
ring and discard.
5. Plug hose and cooler.
6. Release left hand fog lamp breather tubes from
radiator bracket clips.