Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)08 · Steering
08 · Steering & suspension

Bolt (intermediate shaft) removal note

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Power Steering › Bolt (intermediate shaft) removal note
SteeringBolt (intermediate shaft) removal note
  1. Remove the ABS wheel-speed sensor. (See FRONT ABS WHEEL-SPEED SENSOR REMOVAL/INSTALLATION .)
  2. Remove the front stabilizer. (See FRONT STABILIZER REMOVAL/INSTALLATION .)
  3. Remove in the order indicated in Fig. 15.
  4. Install in the reverse order of removal.
  5. After installation, adjust the total toe-in. (See FRONT WHEEL ALIGNMENT .)
STEERING – Power Steering – figure
Fig. 15: Removing & Installing Steering Gear & Linkage (With Torque Specifications)
Courtesy of MAZDA MOTORS CORP.

BOLT (INTERMEDIATE SHAFT) REMOVAL NOTE

  1. Mark the pinion shaft and gear housing for proper installation.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.