Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)08 · Steering
08 · Steering & suspension

Steering wheel installation note

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Power Steering › Steering wheel installation note
SteeringSteering wheel installation note
STEERING – Power Steering – figure
Fig. 14: Steering Shaft Nuts
Courtesy of MAZDA MOTORS CORP.

STEERING WHEEL INSTALLATION NOTE

  1. Make sure the wheels in the straight-ahead position, and install the steering wheel.

STEERING GEAR AND LINKAGE REMOVAL/INSTALLATION

CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place where the sensor will not be pulled by mistake while servicing the vehicle.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.