Adjusting cover assembly note
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Power Steering › Adjusting cover assembly note
SteeringAdjusting cover assembly note · page 1 of 3
Courtesy of MAZDA MOTORS CORP.
ADJUSTING COVER ASSEMBLY NOTE
- Set the rack to the center position.
- Tighten the adjusting cover to 20 N.m {2.0 kgf.m, 15 ft.lbf} .
- Rotate the pinion shaft thoroughly three times to make sure that the pinion shaft and the rack engage smoothly, then loosen the adjusting cover.
- Retighten the adjusting cover to 4.9 N.m {0.5 kgf.m, 3.6 ft.lbf} , then loosen it about 0 to 15° using the SST .
Parts & tools for this job For 2006 Mazda MX-5
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Mazda power steering fluid
As an Amazon Associate we earn from qualifying purchases.