Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)08 · Steering
08 · Steering & suspension

Adjusting cover assembly note (page 2 of 3)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Power Steering
SteeringAdjusting cover assembly note · page 2 of 3
STEERING – Power Steering – figure
Fig. 42: Tightening Adjusting Cover
Courtesy of MAZDA MOTORS CORP.
  1. Measure the rotation torque in the range +/-90+/- from the pinion gear neutral point using a SST and a pull-scale.
    • If not within the specification, repeat Steps 2 - 4 .

Pinion shaft rotation torque

Center of rack +/-90+/-: 0.98-1.38 N.m {10.0-14.0 kgf.cm, 8.7-12.2 in.lbf}

[Pull scale reading: 9.8-13.8 N {1.00-1.40 kgf, 2.21-3.10 lbf}]

Except center of rack +/-90+/-: Less than 1.87 N.m {19.1 kgf.cm, 16.6 in.lbf}

[Pull scale reading: Less than 19.5 N {1.99 kgf, 4.38 lbf}]

  1. Apply sealant to the thread of the locknut.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.