Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)08 · Steering
08 · Steering & suspension

Steering gear and linkage removal note

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Power Steering › Steering gear and linkage removal note
SteeringSteering gear and linkage removal note · page 1 of 2
STEERING – Power Steering – figure
Fig. 17: Separating Tie-Rod End From Steering Knuckle Using SSTs
Courtesy of MAZDA MOTORS CORP.

STEERING GEAR AND LINKAGE REMOVAL NOTE

  1. Remove the steering gear and linkage by pulling it from the right side.

STEERING GEAR AND LINKAGE INSTALLATION NOTE

  1. Tighten bolts loosely.
  2. Assemble the mounting bracket with the mark on the bracket facing the vehicle rear.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.