COMPRESSION PRESSURE - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › COMPRESSION PRESSURE - Nissan 200SX S12 Workshop Manual
COMPRESSION PRESSURE
COMPRESSION PRESSURE
Measurement of Compression Pressure
4, Attach a compression tester.
1. Warm up engine.
Remove ail spark plugs. 2, ‘Use a suitable plug wrench shown below.
Weonch with a magnet {to holed spark plug
36mm {.s3in) seme20A open to fully accelerator pedal Depress
5. throttle, Crank engine and read gauge indication of each eeuzoaa | 6. cylinder. Compression pressure:
kPa (kg/em?, psi) at 360 rpm
3, Disconnect distributor harness connector.
Standard GARDE arine 1,177 (12.0, 171) " Minimum 883 (9.0, 128) Differential limit between cylinders: 98 (1.0, 14) at 360 rpm
7. \f cylinder compression in one or more cyl:
inders is low, pour a small amount of engine
oil into cylinders through the spark plug holes
and retest compression. If adding oil helps the compression pressure, ©
chances are that piston rings are worn or dam-
aged. If pressure stays low, valve may be sticking or © seating improperly. If cylinder compression in any two adjacent © cylinders is low, and if adding oil does not help
the compression, there is leakage past the
gasket surface.
emer
EM-4
Parts & tools for this job For Nissan 200SX
- PARTEngine gasket setSearch: Nissan 200SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.