Workshop Manuals Factory service & repair Nissan and Datsun
01 Nissan-S110 S12 S13 S14 S15 Silvia 200SX 240SX02 INDEX03 GI - General Information04 MA - Maintenance05 EM - Engine Mechanical06 LC - Engine Lubrication & Cooling07 EF&EC - Fuel & Emission Control08 FE - Engine Control, Fuel & Exaust09 CL - Clutch10 MT - Manual Transmission11 AT - Automatic Transmission12 PD - Propeller Shaft & Differential13 FA - Front Axle & Suspension14 RA - Rear Axle & Suspension15 BR - Brake System16 ST - Steering System17 BF - Body18 HA - Heater & Air Conditioner19 EL - Electrical System20 Inch/Metric Converion Tables21 Quick Reference Chart
Nissan and Datsun Nissan 200SX S12 1986 Workshop Manual05 · EM - Engine Mechanical
05 · Engine

EM - Engine Mechanical: ENGINE OVERHAUL - Nissan 200SX S12 Workshop Manual

Make
Nissan and Datsun
Model
200SX Nissan 200SX S12 1986 Workshop Manual
Section
General › EM - Engine Mechanical: ENGINE OVERHAUL - Nissan 200SX S12 Workshop Manual
EM - Engine MechanicalEM - Engine Mechanical: ENGINE OVERHAUL - Nissan 200SX S12 Workshop Manual

EM - Engine Mechanical: ENGINE OVERHAUL

ENGINE OVERHAUL

Inspection {Cont’d)

PISTON TO CYLINDER WALL CLEARANCE

Rebored size calculation D=A+8—C=A + [0,005 10 0,025 mm

1. Measure piston diameter. {0.0002 to 0.0010 in}] Piston diameter “A”: where, Refer to S.D.S. D : Honed diameter (Distancs from the Measuring point Skirt diameter as measured A bottom}: Piston-to-wall clearance B

19.8 mm {0.780 in}: CA20E Machining aitowence c

21.6 mm (0.846 in): CA1BET

0.02 mm (0.0008 in}

Boring

CAUTION: To prevent strain due to cutting heat, bore the

a. cylinders in the order of 2-4-1-3,

b. Before boring any cylinder, install main bearing caps in place and tighten to the specification s0 that the crankshaft bearing bores will not be- ‘coms distorted from the boring operation. sEMO20A, Do not bore too much out of cylinder bore at 8

3. time, Cut only 0.05 mm (0.0020 in} or so in diameter at a time.

2. Check that piston clearance is within the speci- 4, Ase final step, cylinders should be honed to fication, siz Piston clearance: 6, Measure the finished cylinder bore for out-of-

0.025 - 0,045 mm (0.0010 - 0.0018 in) round or tapered part. Refer toS.D.S,

3. Measure the extracting force by pulling feeler Measurement of a just machined cylinder bors gauge straight upward. requires utmost care since it is expanded by cut Feeler gauge thickness: ting heat. 0,04 mm (0.0016 in) Extracting force:

2.0 - 14.7 N(0.2- 1.6 kg, 0.4 - 3.3 Ib)

EM-30

Parts & tools for this job For Nissan 200SX

As an Amazon Associate we earn from qualifying purchases.