EM - Engine Mechanical: ENGINE OVERHAUL - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › EM - Engine Mechanical: ENGINE OVERHAUL - Nissan 200SX S12 Workshop Manual
EM - Engine Mechanical: ENGINE OVERHAUL
ENGINE OVERHAUL
Assembly (Cont‘d) Apply engine oil to main bearing surfaces on 2) Install piston rings. 2, both sides of cylinder block and cap. Install crankshaft.
3.
Install caps with lower main bearings and
Mare ode
4. tighten bolts to specified torque. Main besring cap bolt 1: 44 -54.Nem {4.5 -5.5 kgm, 33 - 40 ft-lb) Arrange the parts so that the indicated number ‘on bearing cap is in a row from the front of engine. Prior to tightening bearing cap bolts, place seNG210 bearing cap in proper position by shifting crankshaft in the axial direction. Tighten bearing cap bolts gradually in sepe- rating two or three stages and outwardly from CRANKSHAFT
1. Set main bearings in the proper position on
center bearing in sequence. cylinder block,
seMeIe
{f either crankshaft, cylinder bleck or main
esting is reused again, it is necessary to measur i main bearing clearance,
Upper bearings (Cylinder block side) have oil
groove.
sEMs928
EM-32
Parts & tools for this job For Nissan 200SX
- PARTEngine gasket setSearch: Nissan 200SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.