CYLINDER HEAD - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › CYLINDER HEAD - Nissan 200SX S12 Workshop Manual
CYLINDER HEAD
CYLINDER HEAD
Inspection (Cont'd) Replacement
3. Heat cylinder head to 150 to 160°C (302 to
Réplaee valvw endl/ar valve quid: 320°F) and press service valve guide into
1, To remove valve guide heat cylinder head to
cylinder head.
180 to 160°C (302 to 320°F} and drive out valve guide with a press [under a 20 KN (2t, 2.2 me ea US ton, 2.0 Imp ton} pressure] or hammer, end j (o.ace - 0.408) and suitable tool, Al V7 al |
ae ee Ta tntake < Exhaurt Unit: morn tind eae
4, Ream valve guide. amen Finished size: mm (in)
7.000 - 7.018 (0.2756 - 0.2763)
seMen6a Ream cylinder head valve guide hole. 2, seMmoo7a Refer to $.D.S,
VALVE INSERTS
Check valve inserts for any evidence of pitting at valve contact surface, and reseat or replace if worn ‘out excessively. © When repairing valve inserts, check valve and valve guide for wear beforehand. If worn, replace them, Then correct valve seat. ‘* The cutting should be done with both hands for uniform cutting.
EM-13
Parts & tools for this job For Nissan 200SX
- PARTEngine gasket setSearch: Nissan 200SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.