CYLINDER HEAD - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › CYLINDER HEAD - Nissan 200SX S12 Workshop Manual
CYLINDER HEAD
CYLINDER HEAD
Removal Disassembly 1,
Remove sir intake pipe (CA1BET engine).
1. Remove manifolds from cylinder head. 2, Remove timing belt.
2. Remove rocker shafts with rocker arms and
Sat No, 1 cylinder at T..C. on its compression
securing bolts, stroke. Before removal, fully loosen rocker arm adjusting After removing timing belt, do not rotate crank- screws, shaft and camshaft separately, because valves will The bolts should be toosened in two or thre hit piston heads. stages,
3. Remove camshaft pulley.
3. Remove camshaft and camshaft oil seal. 2
semez0a Bolts should be loosened in two or thraa stages.
7 SEMB75A,
5. Remove valve oil seals.
EM-11
Parts & tools for this job For Nissan 200SX
- PARTEngine gasket setSearch: Nissan 200SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.