OIL SEAL REPLACEMENT - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › OIL SEAL REPLACEMENT - Nissan 200SX S12 Workshop Manual
OIL SEAL REPLACEMENT
OIL SEAL REPLACEMENT
Replacement of Crankshaft __ — Replacement of Camshaft Oil Seal Rear Oil Seal 1, Remove timing belt and camshaft sprocket.
2. Remove camshalt oii seal.
4. Remove flywheel and rear oil seal retainer.
2. Remove rear oil seal from the retainer, Suitable too!
Paste hammer
semssaa Be careful not to scratch camshaft.
3. Apply engine ail to camshaft oil seal and instal! it in place. 3, Apply engine oi! to oi! seal and install it in place.
4. Install rear oil seal retainer with gasket. Tl: 4-6Nm
~__. Replacement of Crankshaft
(0.4 - 0.6 kg-m, 2.9 - 4.3 ft-lb)
Front Oil Seal
Remove oil pump assembly.
1. Remove crankshaft oil seal.
2.
——— Oil Seal Instalting Direction.
Engine outside
Oust seo! Up 01 sa tip
SEMBsaa semrten
3. Apply engine oil to oil seal and install it in place.
EM-20
Parts & tools for this job For Nissan 200SX
- PARTOil filterSearch: Nissan 200SX oil filter
- TOOLOil filter wrenchSearch: oil filter wrench
- FLUIDEngine oilSearch: Nissan 200SX engine oil
As an Amazon Associate we earn from qualifying purchases.