CYLINDER HEAD - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › CYLINDER HEAD - Nissan 200SX S12 Workshop Manual
CYLINDER HEAD
CYLINDER HEAD
Installation 1, Set No. 1 cylinder at T.D.C, on its compression
3. Tighten cylinder head bolts. stroke a8 follows:
Tighten cylinder head bolts to the specified torque,
{1) Set crankshaft key neer to the top. referring to the procedures below.
—Hesd batt = Near the top Waster
Fat face downweed
SEMsB4A Beit seMs824 @. Tightening order (2) Set camshaft pin on the top.
® ® Ei ‘This bolt i tha longest, sems2? SEMo06
b. Tightening procedure
(1) Tighten all bolts to 29 N-m (3.0 kg-m, 22
Do not rotate crankshaft and camshaft separately,
ft-lb). becouse valves will hit piston heads,
(2) Tighten all bolts to 78 N-m (8.0 kg-m, 58
frelb).
2. Install cylinder head with new gasket. {3} Loosen all boits completely, Be sure to install washers between bolts and head.
(4) Tighten all bolts to 29 N-m (3.0 kgm, 22
ft-lb).
(5) Tighten all bolts to 74 to 83 N.m {7.5 to 8.5
kg-m, 54 to 61 ft-lb) or if you have an angle wrench, turn bolt @ 83 to 88 degrees and the other bolts 75 to 80 degrees clockwise.
EM-17
Parts & tools for this job For Nissan 200SX
- PARTEngine gasket setSearch: Nissan 200SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.