EM - Engine Mechanical: ENGINE OVERHAUL - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › EM - Engine Mechanical: ENGINE OVERHAUL - Nissan 200SX S12 Workshop Manual
EM - Engine Mechanical: ENGINE OVERHAUL
ENGINE OVERHAUL
——_ Inspection (Cont'd) ee
Using @ bore gauge, measure cylinder bore for
CYLINDER BORING
wear, out-of-round or taper
When any cylinder needs boring, all other cylinders
‘Standard inside diameter: Must also be bored at the same time, Refer to $.D.8. Wear limit: Determining bora si
0.20 mm (0.0079 in)
1.
Determine piston oversize according to amount
Out-of-round (X-Y) limit: of wear of cylinder,
0.02 mm (0.0008 in)
Oversize pistons are available for service. Refer to
Taper (4-B} limi SDS.
0.02 mm {0.0008 in)
2.
The size to which cylinders must be honed is,
determined by adding _piston-to-cylinder clearance to the piston skirt diameter “A”, Moving the bore gouge a1 shown, take the mioiinuen diameter.
\ semsooa
SEMBBOA
Units men a) SEMso6
Check for scratches or seizure, If seizure is found,
hone it. eMize Bimension
19.8 mam (0,780 i
21.5 mm (0.846 i
EM-29
Parts & tools for this job For Nissan 200SX
- PARTEngine gasket setSearch: Nissan 200SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.