Caution:

WARNING: Before removing the modulator-to-ABS pump assembly high-pressure line, be sure to relieve the high pressure fluid from the maintenance bleeder.

CAUTION:

• Be careful not to bend or damage the brake pipes when removing the ABS pump assembly.
• Do not allow brake fluid to come into contact with paintwork as it will cause surface damage. If brake fluid does contact the paint, wash it off immediately with water.
• To prevent spills, cover the hose joints with cloth or disposable towels.
• Before reassembling, check that all parts are free of dust and other foreign particles.
• Do not mix different brands of brake fluid as they may not be compatible.
• Do not reuse the drained fluid. Use only clean DOT 4 brake fluid.
• When connecting the brake pipes, make sure that there is no interference between the brake pipes and other parts.
• Do not disassemble the ABS pump assembly except the pressure switch.

1. Drain the brake fluid from the modulator reservoir.
2. Relieve the high pressure fluid.
3. Remove the battery tray.
4. Disconnect the motor and pressure switch connectors.
5. Disconnect the high pressure pipe from the pressure hose joint.
6. Disconnect the brake hose from the ABS pump assembly.
7. Remove the three mounting bolts, and the ABS pump assembly.
8. Remove the ABS pump assembly bracket.
9. Remove the high-pressure hose from the ABS pump assembly.
10. Install the ABS pump assembly in the reverse order of removal.
11. After installation, fill and bleed air from the ABS.