Fiat
Stilo Factory Service Manual (2001-2007)
Engine
Timing system
Timing system guard assemblies - r + r

08 · Engine

Timing system guard assemblies - r + r

Make: Fiat
Model: Stilo Factory Service Manual
Year: 2001–2007
Section: Timing system › Timing system guard assemblies - r + r

‹ Prev Timing system protective cover(s) - r + r Next › Introduction - TIMING SYSTEM

EngineTiming system guard assemblies - r + r

Timing system guard assemblies - r + r

Operation 1032D34 · Timing system protections

1.6 16v

Removing

Place the vehicle on a ramp.

- 1016A10 sound-proofing cover - r + r

- 5530B56 BATTERY DRIP TRAY COVER - R.R.

Disconnect the battery negative terminal.

	Name	Connector
	Battery	A1

- 7055B54 under-engine guard - r r

- 7055B42 Additional FRONT WHEEL ARCH (one), left or right - R.R.

- 4450B10 Front WHEEL (one) - R.R.

- 1092B50 alternator/air conditioner compressor drive belt - adjust tension

- 1008B10 power unit front mount (timing side) flexible block - replace

- 1008A46 cam shaft left rigid mount - r r

- 1032D12 timing system protective cover(s) - r + r

- 1092A10 Crankshaft services PULLEY - R.R.

- 1056B82 injection/ignition system e.c.u. (one) - r + r

- 1056B87 ignition/injection system control unit mount - r r

- 1036G49 rear camshaft seal, lh or rh - r r with mount and coil/s removed

- 1032B10 toothed timing belt - r + r for timing adjustment or replacement

- 1032B40 toothed-driven pulley (one) - r + r with timing belt removed

1. Undo the bolts (1a) and remove the upper rear timing gear cover (1b).

1. Undo the bolts (1a) and remove the lower rear timing gear cover (1b).

Refitting

Refit the lower rear engine flywheel protection in its seating and fix it using the bolts.

Refit the upper rear engine flywheel protection in its seating and fix it using the bolts.