Wiring harness - supplementary (page 2 of 2)

Refit

17. Position harness in footwell and route harness into engine bay, follow evaporator and receiver drier hoses to receiver drier.
18. Fit grommet and ’P’ clip to harness.
19. Position harness between centre console and bulkhead with multiplugs in fusebox area.
20. Secure earth eyelet to fusebox bracket.
21. Connect multiplugs to main harness.
22. Position switch harness to RH side of console, fit fusebox cover and secure with screws.
23. Connect multiplug to trinary switch and condenser fan fly-lead.
24. Secure earth eyelet to fender.
25. Connect multiplug to compressor fly-lead.
26. Secure harness to air conditioning hoses with ties.
27. Secure harness to engine harness with tie.
28. Fit evaporator. See evaporator
29. Perform leak test on disturbed joints
30. Carry out system test. See Adjustment, System test