L322 Range Rover Service Procedures
DRIVESHAFTS
REPAIRS
47-15
'O' Ring - driveshaft housing
$% 47.10.43
Remove
1. Remove RH drive shaft seal.
2. Remove 4 bolts, remove support housing and
discard 'O' ring.
NOTE: Do not carry out further dismantling if
component is removed for access only.
Refit
1. Clean 'O' ring groove, housing and mating face.
2. Lubricate new 'O' ring and fit to housing.
3. Carefully fit housing and tighten bolts to 22 Nm
(16 lbf.ft).
4. Fit RH drive shaft seal.
Drive shaft - rear
$% 47.11.01
Remove
1. Raise rear of vehicle.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
2. Remove road wheel.
3. Remove 6 bolts securing drive shaft to
differential drive flange and collect 3 bolt plates.
Discard bolts.
4. Release drive shaft hub nut stake.
5. With an assistant applying brakes, remove and
discard drive shaft hub nut.
6. Remove brake disc.