L322 Range Rover Service Procedures
DRIVESHAFTS
47-8
REPAIRS
28. Tighten bolt securing lower arm to subframe to
165 Nm (121 lbf.ft), plus a further 90
°
.
CAUTION: Nuts and bolts must be tightened
with vehicle at normal ride height.
29. Tighten bolt securing tie rod to subframe to 165
Nm (121 lbf.ft), plus a further 90
°
.
30. Top-up differential with oil.
ADJUSTMENTS, Front differential - drain
and refill.
31. Check front wheel alignment.
wheel alignment - check & adjust.
Gaiter - bell & joint - outer - front
$% 47.10.03
Remove
1. Remove drive shaft.
2. Place drive shaft in vice.
3. Release and discard both drive shaft gaiter
clips.
4. Slide gaiter along shaft to gain access to outer
joint.
5. Using a drift against the inner part of the joint,
remove joint from shaft.
6. Remove circlip from shaft and discard.
7. Remove gaiter from shaft.
M47 0422