L322 Range Rover Service Procedures
ENGINE - V8
OVERHAUL 12-2-89
Cylinder head - overhaul
$% 12.29.19.01
Disassembly
1. Remove 2 nuts securing exhaust camshaft
drive chain tensioner, remove tensioner and
discard 'O' ring.
2. Remove 5 bolts securing VCC oil distribution
housing. Remove sealing washer from long bolt
and discard washer.
3. Remove VCC oil distribution housing, remove
and discard gasket.
NOTE: If distribution unit is worn, move unit
backwards and forwards to release from
sealing rings.
4. Carefully release and remove 3 VCC oil
distribution sealing rings from the inlet
camshaft.
5. Fit an M10 bolt into the VCC non-return valve
and by hand, remove the valve from the
cylinder head. Discard 'O' ring.
6. Check camshaft end-float using a DTI.