L322 Range Rover Service Procedures
FRONT SUSPENSION
60-20
REPAIRS
Bushes - tie rods
$% 60.40.12
Caution: Bushes must be replaced in pairs.
Remove
1. Remove tie rod.
FRONT SUSPENSION, REPAIRS, Tie
2. Using LRT-60-032/1 and LRT-60-032/2 press
bush from tie rod.
Refit
1. Ensure bush and bore are clean and free from
grease.
2. Align bush as shown and fit bush using LRT-
60-032/1 and LRT-60-032/3.
3. Fit tie rod.
FRONT SUSPENSION, REPAIRS, Tie
4. Repeat procedure for other side.
Air reservoir
$% 60.50.03
The pressure switch in the air reservoir must not be
removed. It is supplied with the air reservoir.
When removing Voss connectors from any air
suspension component the connector must be left
attached to the air pipe being removed. Do not
remove the connector from the air pipe. Removing
the connector from the air pipe could cause the
connector to scratch the pipe and increase the
likelihood of leaks.
Remove
1. Raise front and rear of vehicle and support
under body.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
2. Remove valve block assembly.
3. Remove 6 bolts and 2 nuts securing fuel tank
shield and lower shield for access.