L322 Range Rover Service Procedures
FRONT SUSPENSION
REPAIRS
60-5
6. Remove link and collect washer fitted to top ball
joint.
CAUTION: Note position of washer for refit.
Refit
1. Fit washer to ball joint, fit anti-roll bar link, fit
nuts and tighten to 100 Nm (74 lbf.ft).
CAUTION: The washer is hardened and
must be fitted in the correct position.
2. Fit road wheel and tighten nuts to 140 Nm (103
lbf.ft).
3. Remove stands and lower vehicle.
Ball joint - tie rod
$% 60.15.04
Remove
1. Raise front of vehicle.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
2. Remove road wheels.
3. Loosen bolt securing lower arm to subframe
one quarter of a turn.
4. Remove nut securing height sensor link to
lower arm and release link.
CAUTION: Use an open ended spanner on
flats provided to prevent ball joint rotating.
5. Remove nut securing lower arm ball joint to
hub.