L322 Range Rover Service Procedures
FRONT SUSPENSION
60-18
REPAIRS
Refit
1. Ensure sensor and mounting bracket mating
surfaces are clean.
2. Position height sensor to mounting bracket, fit
Allen screws and tighten to 5 Nm (3.7 lbf.ft).
3. Connect link to height sensor, fit nut and tighten
to 8 Nm (6 lbf.ft).
CAUTION: Ensure height sensor arm is
pointing outwards.
4. Connect multiplug and secure harness with
cable tie, taking care not to exert excessive
tension on wires as they enter multiplug.
CAUTION: Ensure 'O' ring seal is correctly
located in multiplug.
5. Fit road wheel and tighten nuts to 140 Nm (103
lbf.ft).
6. Remove stands and lower vehicle.
7. If a replacement sensor has been fitted, use
TestBook/T4 to re-calibrate system.
ADJUSTMENTS, Calibrate - air suspension.
Tie rod
$% 60.40.09
Remove
1. Raise front of vehicle.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
2. Remove road wheel.
3. Remove nut securing height sensor link to
lower arm and release link.
4. Loosen bolt securing lower arm to subframe
one quarter of a turn.
5. Remove nut securing ball joint to lower arm.
6. Using LRT-54-027 release lower arm ball joint
and disconnect lower arm from hub.
CAUTION: Ensure ball joint seal is not
damaged. A damaged seal will lead to
premature failure of the joint.
M60 0789
LRT -54-027