COMPRESSOR — Precautions - Nissan 180SX S13 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 180SX Nissan 180SX S13 1989 Workshop Manual
- Section
- General › COMPRESSOR — Precautions - Nissan 180SX S13 Workshop Manual
‹ Prev COMPRESSOR OIL—For DKV-14C (DIESEL-KIKI make) - Nissan 180SX S13 Workshop ManualNext › COMPRESSOR — Model NVR 1408S (ATSUGI make) - Nissan 180SX S13 Workshop Manual
HA heater & airconCOMPRESSOR — Precautions - Nissan 180SX S13 Workshop Manual
COMPRESSOR — Precautions
COMPRESSOR — Precautions
@
Plug all openings to prevent moisture and foreign matter
from entering. @
Do not leave compressor on its side or upside down for
more than 10 minutes. @
When replacing or repairing compressor, check compres-
sor oil level in system. @
When replacing with a new compressor, drain specified oil
from new compressor. Refer to COMPRESSOR OIL.
@
Be sure there is no oil or dirt on frictional surface of
clutch disc and pulley. @ When replacing compressor clutch, be careful not to scratch shaft or bend pulley. @
When replacing compressor clutch assembly, do not for-
get BREAK-IN OPERATION. @
When storing a compressor, be sure to fill it with refrig-
erant to prevent rust formation. Add refrigerant at the
low-pressure side and purge air at the high-pressure side,
while rotating shaft by hand. @ When replacing parts, always use new O-rings.
HA-43
‹ Prev COMPRESSOR OIL—For DKV-14C (DIESEL-KIKI make) - Nissan 180SX S13 Workshop ManualNext › COMPRESSOR — Model NVR 1408S (ATSUGI make) - Nissan 180SX S13 Workshop Manual
Parts & tools for this job For Nissan 180SX
- TOOLA/C manifold gauge setSearch: AC manifold gauge set
- TOOLUV leak detection kitSearch: AC UV leak detection kit
- PARTCabin filterSearch: Nissan 180SX cabin filter
As an Amazon Associate we earn from qualifying purchases.