Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual26 · HA heater & aircon
26 · General

DOOR CONTROL - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › DOOR CONTROL - Nissan 180SX S13 Workshop Manual
HA heater & airconDOOR CONTROL - Nissan 180SX S13 Workshop Manual

DOOR CONTROL

| {

DOOR CONTROL

Control Cable Adjustment

@ When disconnecting the control cable, remove the E-ring and take off the cable while pushing the cable outer. ® The following illustrations are for L.H. drive models. For R.H. drive models, it is basically same.

MODE DOOR

]. Move side link with hand and hold mode door in VENT mode.

2. Install mode door motor on heater unit and connect it to body harness. Side link

3. Turn ignition switch to ACC.

4. Turn VENT switch ON.

5. Attach mode door motor rad to side link rod holder. 6 Turn DEF switch ON. Check that side link operates at the fully-open position. Also turn VENT switch ON to check that side link operates at the fully-open position.

Mode door motor AHAR7T4A

WATER COCK CONTROL ROD

—N » Air mix door lever @ When adjusting water cock control rod, first disconnect temperature control cable from air mix door lever. Re- connect and readjust temperature control cable. eh Push air mix door lever in direction of arrow. Pull control rod of water cock in direction of arrow so as to TD make clearance of about 2 mm (0.08 in) between ends of rod and link lever and connect the rod to door lever. After connecting control rod, check it operates properly.

TEMPERATURE CONTROL CABLE

@ Clamp the cable while pushing cable outer and air mix door lever in direction of arrow. After positioning control cable, check it operates properly.

Air mix door fever rae ~ RHASTEA sy

HA 6

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.