Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual26 · HA heater & aircon
26 · General

DESCRIPTION — Push Control - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › DESCRIPTION — Push Control - Nissan 180SX S13 Workshop Manual
HA heater & airconDESCRIPTION — Push Control - Nissan 180SX S13 Workshop Manual

DESCRIPTION — Push Control

DESCRIPTION — Push Control

Intake Door Motor

Intake

The intake door motor is installed on the front portion of the

intake unit. Using a rod and link it opens and closes the intake door. When the REC switch is ON (OFF), the ground line of the intake

door motor is switched from terminal @ to @ (@ to q). This

causes the motor to start because the position switch contacts

built into it are set to the current flow position. The contacts

turn along with the motor. When they reach the non-current

TT

flow position, the motor will stop. The motor always turns in the

IGNITION: SWITCH

ACC or ON same direction.

® oF L-H. drive Intake model door wabstot moter (ob<L9 11] RH drive madel [ «| Lol<tt1] 9] To push contre |

Mode Door Motor

L.H.D. MODEL

The mode door motor is located on the left side of the heater

unit. Through the side link it opens and closes the vent, foot

and defroster door.

When one mode switch is pushed, the position switch built into

it reads the corresponding mode to determine the direction of

the motor rotation. As soon as the desired mode is set, the

position switch stops the motor. Mode door motor — [e (le [S[o}3teli Del z ig) *: Current flows as indicated by the arrow, motor actuates as Indi- cated by the words, To push cantrol

Terminal No. Mode door motor Direction oO)

Mode door | oF linkage

operation . rotation Stop Stop Q S) e) © |VENT+DEF { Clockwise Counter- ® ©

DEF VENT

clockwise

RHAIgOA

HA-10

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.