DESCRIPTION —~ Push Control - Nissan 180SX S13 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 180SX Nissan 180SX S13 1989 Workshop Manual
- Section
- General › DESCRIPTION —~ Push Control - Nissan 180SX S13 Workshop Manual
DESCRIPTION —~ Push Control
DESCRIPTION —~ Push Control
Mode Door Motor (Cont'd)
R.H.D. MODEL
The mode door motor is located on the right side of the heater unit. Through the side link it opens and closes the vent, foot and defroster door. When one mode switch is pushed, the position switch built into it reads the corresponding mode to determine the direction of the motor rotation. As soon as the desired mode is set, the position switch stops the motor.
ie (ei Li2 is isis lé Dei?) *: Current flows as indicated by the arrow, motor actuates as indi- cated by the words. To Push < control
Terminal No. Mode door motor Direction @) |-
Mode door | oF tinkage
operation . rotation (o) 2) Stop Step Counter- © @®
|VENT -~ DEF
clockwise |DEF>VENTI Clockwise ) © RHAG3IA
HA-11
Parts & tools for this job For Nissan 180SX
- TOOLA/C manifold gauge setSearch: AC manifold gauge set
- TOOLUV leak detection kitSearch: AC UV leak detection kit
- PARTCabin filterSearch: Nissan 180SX cabin filter
As an Amazon Associate we earn from qualifying purchases.