Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual26 · HA heater & aircon
26 · General

DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 180SX S13 Workshop Manual
HA heater & airconDISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 180SX S13 Workshop Manual

DISCHARGING, EVACUATING, CHARGING AND CHECKING

DISCHARGING, EVACUATING, CHARGING AND CHECKING

| Point-7

Run engine at idling (Below 1,500 rpm) To high-pressure To low-pressure Charging service valve service valve

1. Charge refrigerant into system.

WARNING: Turn Ciose Ensure that engine is off. in or out @® Open jiow-pressure valve of manifold gauge and charge refrigerant into system. Fan tever mode and

2. When refrigerant charging speed slows down, close high- temperature dial: in Zl pressure valve of manifold gauge and open low-pressure Maximum cold and speed SHA245B vaive of manifold gauge and charge it while running the compressor for ease of charging.

3. Start engine — Air conditioning system ON, maximum temperature set, maximum blower speed. Open low- pressure valve on gauge set, with can in upright position, and monitor sight glass. Charge is complete when sight glass is clear. Cycling clutch systems will produce bubbles in sight glass when clutch engages. Therefore, allow 5 seconds after clutch engages to determine if bubbles continue, and, if so, add refrigerant to clear sight glass.

WARNING: Never charge refrigerant through high-pressure side (dis- charge side) of system since this will force refrigerant back into refrigerant can and can may explode.

4. Charge refrigerant while controlling low-pressure gauge reading at 275 kPa (2.75 bar, 2.8 kg/cm’, 40 psi) or less by turning in or out low-pressure valve of manifold gauge. @ Be sure to purge air from charging hose when replacing can with a new one.

5. Charge the specified amount of refrigerant into system by weighing charged refrigerant with scale. Overcharging will cause discharge pressure to rise. Refrigerant amount: L.H.B. model

0.9 - 1.0 kg (2.0 - 2.2 Ib) R.H.D. model

0.8 - 0.9 kg (1.8 - 2.0 Ib)

RHASO4

HA-24

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.