Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual26 · HA heater & aircon
26 · General

PRECAUTIONS FOR REFRIGERANT CONNECTION - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › PRECAUTIONS FOR REFRIGERANT CONNECTION - Nissan 180SX S13 Workshop Manual
HA heater & airconPRECAUTIONS FOR REFRIGERANT CONNECTION - Nissan 180SX S13 Workshop Manual

PRECAUTIONS FOR REFRIGERANT CONNECTION

PRECAUTIONS FOR REFRIGERANT CONNECTION

WARNING:

Gradually loosen discharge side hose fitting, and remove it

Torque wrench after remaining pressure has been released.

CAUTION:

When replacing or cleaning refrigerant cycle components,

observe the following.

@ Do not leave compressor on its side or upside down for

more than 10 minutes, as compressor oil will enter low

pressure chamber.

@ When connecting tubes, always use a torque wrench.

SHAB9IBA @ After disconnecting tubes, plug all openings immediately to prevent entrance of dirt and moisture.

SHAOSS e@ Always replace used O-rings. Do not apply O-ring @ When connecting tube, apply compressor oii to portions compressor oi. Apply com- shown in illustration. Be careful not to apply oil to pressor oil. threaded portion. @ O-ring must be closely attached to inflated portion of tube. —w | Z o

sh portion

2 oie A oO SHABSTA

@ After inserting tube into union until O-ring is no longer

visible, tighten nut to specified torque.

@ After connecting line, conduct leak test and make sure

that there is no leakage from connections. When the gas

leaking point is found, disconnect that line and replace the

O-ring. Then tighten connections of seal seat to the

specified torque.

a = -—— a SHABSBA HA-18

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.