Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual26 · HA heater & aircon
26 · General

DESCRIPTION OF AIR CONDITIONER - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › DESCRIPTION OF AIR CONDITIONER - Nissan 180SX S13 Workshop Manual
HA heater & airconDESCRIPTION OF AIR CONDITIONER - Nissan 180SX S13 Workshop Manual

DESCRIPTION OF AIR CONDITIONER

DESCRIPTION OF AIR CONDITIONER

Refrigeration Cycle

REFRIGERANT FLOW

The refrigerant flows in the standard pattern, that is, through the compressor, the condenser, the receiver

drier, through the evaporator, and back to the compressor.

The refrigerant evaporation through the evaporator coil is controlled by an externally equalized expansion

valve, located inside the evaporator case.

FREEZE PROTECTION

The compressor cycles on and off to maintain the evaporator temperature within a specified range. When the evaporator coil temperature falls below a specified point, the thermo control amplifier interrupts the compressor operation. When the evaporator coil temperature rises above the specification, the thermo

control amplifier allows compressor operation.

REFRIGERANT SYSTEM PROTECTION

Dual-pressure switch

The refrigerant system is protected against excessively high or low pressures by the dual-pressure switch, located on the receiver drier. If the system pressure rises above, or falls below the specifications, the

dual-pressure switch opens to interrupt the compressor operation.

Fusible plug

Open at temperature above 105°C (221°F), thereby discharging refrigerant to the atmosphere. If this plug

is melted and opened, check the refrigerant line and replace receiver drier.

RG Low-pressure

| High-pressure 3

ELLA yas

P liquid é High-pressure Low-pressure liquid Y gas g Compressor A a 5 S 4 D : _ 4 3 3 } i 4 cE: 3 g Be Outside air J os , Z : 4 :

‘) Condenser

Blower motor

Expansion valve Fusible plug Receiver drier Dual-pressure switch SHA968B

HA-29

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.