Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual26 · HA heater & aircon
26 · General

DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 180SX S13 Workshop Manual
HA heater & airconDISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 180SX S13 Workshop Manual

DISCHARGING, EVACUATING, CHARGING AND CHECKING

DISCHARGING, EVACUATING, CHARGING AND CHECKING

In service A/C system = 1 ¥ When it is necessary to replace When it is not necessary to parts replace parts i 4 Check the spot where mal- Check the spot where function occurs. refrigerant leaks. Point-1 J i Discharging Repair. ¢ ‘ Replace parts. Add refrigerant. L

New A/C systern Point-2 if Evacuating & Run pump for over 5 minutes. Point-3 Point-4 Checking airtightness a OK. *9 q Once evacuating Twice evacuating On condition that pump operates On condition that pump operates over —-98.6 kPa (—986 mbar, —740 below —98.6 kPa (—986 mbar, mmHg, —29.13 inHg) and with low —740 mmHg, —29.13 inHg) and humidity on a clear day. with high humidity ona rainy day. i Point-6 if Point-5 Evacuating Charging Open high-pressure valve of mani- Run pump for over 20 minutes. fold gauge and charge refrigerant into system. When low-pressure gauge reading is 98 kPa (0.98 bar,

1.0 kg/em?, 14 psi), cornpletely close high-pressure valve of mani- fold gauge and stop charging. Point-3 J NG

Checking airtightness

+--+ Point-5 Lok: Evacuating Run pump for over 20 minutes. Point-7 i >| Charging | i LN. |

Checking refrigerant leaks

4 0.K, “1: Depending on the details of malfunction

| Check operation of A/C system.

*2: Working operation depends on the performance of the pump and the weather.

HA-21

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.