Workshop Manuals Factory service & repair Nissan and Datsun
01 Nissan-S110 S12 S13 S14 S15 Silvia 200SX 240SX02 INDEX03 GI - General Information04 MA - Maintenance05 EM - Engine Mechanical06 LC - Engine Lubrication & Cooling07 EF&EC - Fuel & Emission Control08 FE - Engine Control, Fuel & Exaust09 CL - Clutch10 MT - Manual Transmission11 AT - Automatic Transmission12 PD - Propeller Shaft & Differential13 FA - Front Axle & Suspension14 RA - Rear Axle & Suspension15 BR - Brake System16 ST - Steering System17 BF - Body18 HA - Heater & Air Conditioner19 EL - Electrical System20 Inch/Metric Converion Tables21 Quick Reference Chart
Nissan and Datsun Nissan 200SX S12 1986 Workshop Manual11 · AT - Automatic Transmission
11 · Transmission

GENERAL SERVICE NOTICE - Nissan 200SX S12 Workshop Manual

Make
Nissan and Datsun
Model
200SX Nissan 200SX S12 1986 Workshop Manual
Section
General › GENERAL SERVICE NOTICE - Nissan 200SX S12 Workshop Manual
AT - Automatic TransmissionGENERAL SERVICE NOTICE - Nissan 200SX S12 Workshop Manual

GENERAL SERVICE NOTICE

GENERAL SERVICE NOTICE

Repair Notes re proceeding with disassembly, thorough- and requires extreme care when parts are tlsan the outside of the transmission. It is removed and serviced. Place removed parts on

important to prevent the internal parts of the

a parts rack so they can be put back in the

jnsmission from becoming contaminated by

valve body in the same positions and se- quences. Care will also prevent springs and small parts fram becoming scattered or lost. © Before assembly, apply a coat of recommended sa, @ nylon cloth or paper towel for wiping Use A.T-F. to all parts, Vaseline may be applied to parts clean. Common shop rags can leave lint O-rings and seals, Do not use any grease. that might interfere with the transmission © Care should be teken ta avoid damaging O-rings, seals and gaskets when assembling. operation, When disassembling parts, be sure to place Abbreviations used throughout this section stand them in order in parts rack so they can be put for the following: back in the unit in their proper positions. . Automatic transmission fluid

All parts should be carefully cleaned with a

. Drive range 1st gear ineral purpose, non-flammable solvent before . Drive range 2nd gear F inspection or reassembly. . Drive range 3rd gear Guskets, seals, and O-rings should be replaced. . Drive range 4th gear Itis also very important to perform functional ~ Overdrive tests whenever it is designated. . Vrange 2nd gear The valve body contains many precision parts . T range 1st gear

Le Second lock valve Manuel vaive sat742

AT-3

Parts & tools for this job For Nissan 200SX

As an Amazon Associate we earn from qualifying purchases.