ON-VEHICLE SERVICE - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › ON-VEHICLE SERVICE - Nissan 200SX S12 Workshop Manual
ON-VEHICLE SERVICE
ON-VEHICLE SERVICE
— Parking Component (Cont'd). Inhibitor Switch Adjustment —_
5. Remove rear extension bolts, then draw out Disconnect harness at connector, then remove in- rear extension with rear mounting. hibitor switch. © Check continuity at “N" P’" and “R" ranges.
saro20 Remove control valve assembly. © With selector lever held in “Neutral, tum Inspect and repair parking components. Check manual lever an equal amount in both direc: component parts for wear or damage. tions to see if current flow ranges are nearly the same. (Current normally begins to flow before manual lever reaches a angle of 1.5° in either direction.) 'f current flows outside normal range, or if normal flow range is out of specifications, Governor Valve Assembly —____ properly adjust inhibitor switch. Adjust inhibitor switch as follows:
1. Drain oll by removing oil pan,
1. Place the manual valve in Neutral (vertical 2, Remove rear extension with rear mounting. position). 3, Remove governor valve assembly. 2, Remove the screw.
saton |
4. Inspect and repair governor valve assembly. Refer to Governor for inspection.
AT-10
Parts & tools for this job For Nissan 200SX
- PARTTransmission filter kitSearch: Nissan 200SX transmission filter kit
- FLUIDAutomatic transmission fluidSearch: Nissan automatic transmission fluid
- TOOLFluid transfer pumpSearch: fluid transfer pump
As an Amazon Associate we earn from qualifying purchases.