ON-VEHICLE SERVICE - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › ON-VEHICLE SERVICE - Nissan 200SX S12 Workshop Manual
ON-VEHICLE SERVICE
ON-VEHICLE SERVICE
Control Valve.
1. Drain fluid by removing oil pan.
2. Remove kickdown solenoid and vacuum dia-
phragm & rod.
Be careful not to lose vacuum rod. ‘Vacuum diaphragm.
1. 40mm (1.57 in} 2 35mm (1.28in)
3. 25mm (0.98) © After installing control valve to transmission case, make sure that control lever can be moved to all positions,
6. Install kickdown solenoid and vacuum dia- phragm & rod. Make sure that vacuum diaphragm rod does not interfere with side plate of control valve.
Be careful not to drop manual valve out of valve body.
4. Disassemble, inspect and assemble control valve assembly. Refer to Control Valve Body.
5. Install contro! valve assembly, © Set manual shaft at Neutral, then align manual plate with groove in manual valve of control valve assembly. ‘© Securing bolts come in 3 different lengths,
AT-8
Parts & tools for this job For Nissan 200SX
- PARTTransmission filter kitSearch: Nissan 200SX transmission filter kit
- FLUIDAutomatic transmission fluidSearch: Nissan automatic transmission fluid
- TOOLFluid transfer pumpSearch: fluid transfer pump
As an Amazon Associate we earn from qualifying purchases.