Workshop Manuals Factory service & repair Nissan and Datsun
01 Nissan-S110 S12 S13 S14 S15 Silvia 200SX 240SX02 INDEX03 GI - General Information04 MA - Maintenance05 EM - Engine Mechanical06 LC - Engine Lubrication & Cooling07 EF&EC - Fuel & Emission Control08 FE - Engine Control, Fuel & Exaust09 CL - Clutch10 MT - Manual Transmission11 AT - Automatic Transmission12 PD - Propeller Shaft & Differential13 FA - Front Axle & Suspension14 RA - Rear Axle & Suspension15 BR - Brake System16 ST - Steering System17 BF - Body18 HA - Heater & Air Conditioner19 EL - Electrical System20 Inch/Metric Converion Tables21 Quick Reference Chart
Nissan and Datsun Nissan 200SX S12 1986 Workshop Manual11 · AT - Automatic Transmission
11 · Transmission

TROUBLE-SHOOTING AND DIAGNOSES - Nissan 200SX S12 Workshop Manual

Make
Nissan and Datsun
Model
200SX Nissan 200SX S12 1986 Workshop Manual
Section
General › TROUBLE-SHOOTING AND DIAGNOSES - Nissan 200SX S12 Workshop Manual
AT - Automatic TransmissionTROUBLE-SHOOTING AND DIAGNOSES - Nissan 200SX S12 Workshop Manual

TROUBLE-SHOOTING AND DIAGNOSES

TROUBLE-SHOOTING AND DIAGNOSES

Road Testing (Cont'd)

2. Using the shift schedule as 2 reference, drive

4. When vehicle is being driven in the 65 to 85 vehicle in “D” range. Record, on symptom km/h (40 to 53 MPH) range in “D," range at chart, respective vehicle speeds at which up- half to light throttle position, fully depress ac- shifting and downshifting occur. Check that celerator pedal to make sure it downshifts from there is not a considerable jalt when shifting 3rd to 2nd gear. gears. Also determine the timing at which

5. When vehicle is being driven in the 25 to 35 shocks are encountered during shifting and km/h (16 to 22 MPH) {“D," range} at half to which clutches are engaged. light throttle position, fully depress accelerator pedal to make sure it downshifts from 2nd to 1st gear.

“2” RANGE

1. While vehicle is being driven in “2” range, make sure that it does not shift into 1st or 3rd gear, despite speed changes, 2, Move selector lever to “D" range and allow vehicle to operate at 40 to 50 km/h (25 to.31 In, shift to “2” range to make sure

@arsa0 1" RANGE

3. Check to determine if fting to overdrive gear

1. Place selector lever to “1” range and allow cannot be made wi

0.0, control switch is vehicle. Ensure that it does not upshift from “OFF”. 1st to 2nd gear although vehicle speed in. creases.

2. While vehicle is being driven in “1” range, release accelerator pedal to make sure that engine compression acts as a brake

3. Place selector ‘ever into “D" or 2" range and atlow vehicle to run at 20 to 30 km/h (12 to 19 MPH). Then, move selector lever to “1" range to make sure the downshift to 1st gear is made,

savez?

AT-58

Parts & tools for this job For Nissan 200SX

As an Amazon Associate we earn from qualifying purchases.